Preformed Thermoplastic Striping (torch down)
Our 4" , 6" and 12" torch down preformed thermoplastic ROLLS are designed to stripe asphalt or porous cement parking lots, roads, bike paths and any other area where heavy duty, high visibility delineation is needed. It is great for creating crosswalks, car spaces, stop pads, hazard areas, etc.. Also, by scoring and cutting the material you can create symbols like arrows. This product is 90 mils thick and will last 5 times longer than paint. It is reflective and best of all, you can put it down yourself. No contractor required.
Our tape is simple to install using a broom and a propane torch. No contractor required. It is 90 mils thick and has a durable, reflective surface. Since this is a melt on type product the tape will conform and bond to moderately rough surfaces or smooth surfaces and is incredibly tough. When properly installed you will get years of service out of this material. It can handle any type of traffic. When applying to cement remember that the surface must be porous. Smooth, slick cement would need to be ground or blasted to remove the top layer prior to application.
To apply to asphalt simply broom or blow off the dry, oil free area to be striped, heat the area with a propane torch to 300 degrees, lay out the stripe and then slowly heat the surface of the stripe until a permanent bond is created. Once the material has cooled the area is ready for traffic. Please refer to the link above for complete instructions. It is important for this product to be installed properly. Porous cement applications are the same except that care should be taken to not overheat the cement. An infrared thermometer can prevent this. Safety glasses or goggles are recommended.
Our prices are as follows -
6" x 30' Rolls in Yellow - $360.00 per case of three. 2 case minimum. Call us to order.
12" x 30' Rolls in White - $440.00 per case of two. 2 case minimum. Call us to order.
(For all other preformed thermoplastic products such as arrows, letters, symbols, etc.. CLICK HERE for our Pre-Mark Price List in a PDF format and then call us at 850-934-3157 or email me at email@example.com)
Our 4" x 30 foot torch down Preformed Thermoplastic Rolls are designed to stripe asphalt or porous cement parking lots, roads, bike paths and any other area where heavy duty, high visibilty delineation is needed. It is great for creating...
- Price: $79.99